Video Card Power To Sata Wiring Diagram | Wiring Diagram – 4 Pin Molex Connector To Usb Wiring Diagram

Video Card Power To Sata Wiring Diagram | Wiring Diagram – 4 Pin Molex Connector To Usb Wiring Diagram

4 Pin Molex Connector To Usb Wiring Diagram – There are numerous types of electronics out there. Most of them utilize USB cable. The cable may be utilized to transfer data from one apparatus to another. It can also connect device to a power supply for charging purpose. Understanding 4 pin molex connector to usb wiring diagram is be helpful for you.

The diagram for USB cable will help if there’s an problem with it. Knowledge on constituting parts of USB is going to aid consumer in finding out which part that needs to be adjusted. For crafty users who want to build their particular USBs, this diagram will serve as a principle.

Building USB Cable Based on USB Wiring Diagram

USB cable is regarded as quite a serial bus. The cable is composed of four threaded wires. Two cables, GND and +5v, are specifically for power. The remaining two cables are for information signals. They are named as D- and D+. Before studying 4 Pin Molex Connector To Usb Wiring Diagram, there’s another thing to find out about this particular cable.

There are four types of data rates in USB cable. The first one is Low Rate with transfer speed approximately 1.5 Mbit per second. Full rate has transfer rate of about 12 Mbit per second There is also Hi-Speed data transfer speed approximately 480 Mbit per second. The Super rate goes past that with transfer speed of 4800 Mbit per second.

In order to construct a USB cable, you have to gather these substances.

  • Cat-5 cable of desired length
  • USB connectors
  • Shrink tubing
  • Sharp knife
  • Soldering iron
  • Solder
  • Electric meter
  • Stripper for wires

In accordance with 4 Pin Molex Connector To Usb Wiring Diagram, there are only four wires used inside the cable. Typically it uses black, green, red and white wire colours. Black cable serves as ground, just like in every other device. The red one is for sure wire with DC power of 5 volts. Green and white serve as information wire with green indicates white and negative as positive.

If you are utilizing Cat-5 cable subsequently take only four of those wires with colors defined as in the former part. Use the solid cables, instead of the ones that are stripped. Strip to a centimeter in the endings. After that, cover the entire cables with large shrink tubing. Each wire must also be covered by smaller shrink tube.

The next part is also significant in the practice of making USB cable. It is soldering the wires into the connector on a finish. Being neat as possible during this process is quite important. The wires shouldn’t cross each other as then the USB cable can’t be used in any respect. Based upon the 4 Pin Molex Connector To Usb Wiring Diagram, every wire is completely protected from one another.

Following the initial end has been completed, it is time to proceed to the other one. First, the electrical meter should be set into Ohm functioning. Match both ends until the meter produces a sound that indicates closed circuit. After that occurs, it is the right time to solder each wire in their respective parts. Layer the wires with shrink tube also.

When the USB cable has been completely created, it’s time to test this tool. User can check whether the cable may help charging electronic apparatus that supports USB connection. Trying the cable out to check its data transfer capacity can be highly recommended.

Having knowledge of 4 Pin Molex Connector To Usb Wiring Diagram and its components might help user finding out what is wrong with the device when it is not working. In addition, it can help consumer building their own USB cable according to specific demands, such as speed and cable length. Hopefully, this info will be placed to a great use!